![]() You’ll want to drill through the plexiglass and wood at the same time to prevent the plexiglass from splitting. ![]() Doing this right will make sure you end up with an appearance of infinite white space in your photography. Use your clamps or friend to secure the 1x2s to the top of the plexiglass surface on the front and back of your frame to create a smooth curved surface. If you don’t have any, your friend that has a firm grip will work as well. Step 4: Attach the surfaceĪgain, for this part of the construction process, you’ll want a good set of clamps to help you along. Unlike the other pieces, you’ll secure this final piece on the inside of the legs. ![]() It doesn’t have to be precise – it will be based upon how tall you want the back of the plexiglass surface to be. The leftover 24″ piece will need to be attached near the top of the back legs. The other set of 1x4s will need to be attached about halfway between the ground and the previous set you just attached. Next, attach one set of your 1x4s about 31 inches up the back legs so that they’re aligned with the top of the front legs. After you attach the side cross supports to the legs, you’ll then attach the sides together with the front cross support pieces. It’s best to build the sides first by attaching the side cross supports to the legs. To start, you’ll need to attach the 1x4s on the outside of the legs. This project will be hard to complete on your own if you don’t have good clamps. You’ll need clamps or, if you don’t have any, a friend with a firm grip to help you keep the boards squared up with the frame so your photography light table comes out well structured. Make sure you have plenty of space available as you’ll want to build your photography light table on the floor so it’s easier to keep it stable and steady. If you can, grab a friend to help you with this part of the construction process.
0 Comments
Leave a Reply. |